Be Cool Storm isofix Manual De Instrucciones página 34

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
GB
of the shell and whilst holding it, pull the shell
forwards to its most reclined position.
Unlock the lock (D), remove the installation bar
5
(E) and pull the top of the shell forwarders to ac-
cess the space behind the shell more easily.
6
Take the two harness shoulder straps with the
buckle clips and crotch strap and match the
buckle tongue sections together and insert into
the buckle.
Take the buckle connected you will have some-
7
thing similar to the illustration opposite.
Insert waist strap retainer buckles (F) through the
8
two slots (1) and (2) on the cover and out through
the outer slots on the back of the shell then back
through the inner slots.
Insert crotch strap retainer buckle (G) through
slot (3).
Thread strap ends (3) through the shoulder
9
pads (H).
Thread strap ends (3) and (4) through slots (I).
10
Connect the shoulder pad straps (4) to the shoul-
der pad connector (J), connect the shoulder har-
ness straps (3) to the yoke (K).
Return the shell to its original position and rein-
11
sert the installation bar (L) and secure lock (M).
34
MAINTENANCE AND CLEANING
STORAGE
1) Store this child car seat in a safe place when
not in use.
2) DO NOT place heavy objects on top of it.
3) Always store the child car seat in a dry en-
vironment.
4) DO NOT store the child car seat near a di-
rect
heat source such as a radiator.
COVERS
1) The seat cover is easily removable and
should be handwashed with a PH neutral soap
and cold water.
2) DO not press, iron, dry clean,tumble dry or
wring the cover.
3) Do not use solvents, caustic or abrasive
cleaning material.
4) Dry flat, aways from direct heat and sunlight.
5) If the seat cover needs to be replace and is
under warranty-contact your retailer.
PLASTIC / METAL PARTS
1) Wipe clean using a mild soap and warm wa-
ter.
2) You must not remove, dismantle or alter any
part of the seat shell
3) You must not oil or lubricate any part of the
seat shell.
INSPECTION
1) Check your child car seat regularly for wear
and tear.
2) The child car set may have a slight rattle
when not in use, this is normal. If in any doubt,
contact your retailer immediately.

Publicidad

Tabla de contenido
loading

Tabla de contenido