ESAB Origo Manual De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.8) Nozzle selection
TAB E 5.4
L
Diameter (mm)
12
*16
19
* Supplied as standard
6) OPERATION
1) Turn ON the connected power source and adjust the output voltage to an estimate value to the
application.
2) Adjust the speed in the potentiometer of the Spool Gun torch to an estimate adequate value to the
application.
3) Open the shielding gas.
4) Open the electric arc by activating the trigger in the torch to re-adjust the parameters according to the
necessity.
7) MAINTENANCE
7.1) Recommendations
In normal environment and operation conditions the Wire Feeders Origo™ Feed Spool Gun, do not require
any maintenance or special service. It is enough to clean it inside once every two month with low pressure
compressed air, dry and free from oil.
After cleaning the equipment with blow dry air, check that the electric connections and components are
properly fixed. Check for possible faults in the wire isolations or electric cables, including the welding cable
and any others and if any of them is faulty substitute it. When working with damaged wires or cable or with
worn out isolation, the non-isolated parts, can become in contact with another part of an earth connected
object. The electric arc which results from this contact can hurt the eyes if not protected and cause a fire.
The body contact of a part with another conductor without isolation can cause a violent electric hazard,
burns and even death
7.2) Repair
In order to ensure the perfect functioning and performance of ESAB equipment, use only original parts
supplied by ESAB or approved by them. All guarantee undertakings from the supplier cease to apply if the
customer uses non-original or non -approved parts when replacing any of them.
Spare parts can be obtained from the ESAB Authorized Services or from its Sales Distributors listed on the
last page of this Manual. Always inform the Equipment Model and Serial Number of the wire feeder in
question.
Length (mm)
Reference
84
0705541
84
0705518
84
0705542
19
Origo™ Feed Spool Gun

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0401614

Tabla de contenido