Siemens SITRANS FUH1010 Instrucciones De Servicio página 25

Select Liquid Class
1. Trigger <Left Arrow> to select [Pipe Data] and then trigger <Down Arrow> to select
2. Trigger <Right Arrow> to select [Liquid Class].
3. Trigger <Right Arrow> again to select [Liquid Class]. Trigger <Right Arrow> sensor again.
4. Trigger <Up/Down Arrows> to scroll to desired liquid.
5. Trigger <ENTER> to save selection.
Select Pipe Configuration
1. Trigger <Left Arrow> and then <Down Arrow> to select [Pipe Config].
2. Trigger <Right Arrow> sensor.
3. Trigger <Up/Down Arrows> to select a configuration that approximates the conditions
SITRANS FUH1010 Quick Start Guide
Operating Instructions, 1/2009, CQO:QSG009 Rev A
Note
Pre-programmed Pipe Size and relevant pipe parameters will appear in menu cells. To
enter dimensions manually if pre-programmed dimensions do not match application, refer
to flowmeter manual for details.
① Colon must appear first before Pipe Class can be selected.
[Application Data].
① Colon appears
② Select new liquid from list.
upstream of your transducer mounting location. (Refer to the definitions below.)
Commissioning
3.4 Setting the Parameters
23