Installation Instructions; Part Numbers - Cequent Performance Products 41950 Instrucciones De Instalación

Remove this bolt
short-bed. Leave
shield in place
between frame and
hitch bracket.
1
7
Conical toothed washers
and nuts on back side
*4
*3
Use these fasteners when
installing bolt-on brackets
only. Conical toothed
washers and nuts used
other side. (not shown)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
© 2015 Cequent Performance Products – Printed in Mexico

Installation Instructions

GMC Sierra/Chevrolet Silverado 2500 & 3500 HD Pickups.
Looking up underneath passenger side frame rail,
showing plastic spare tire shield
Magnified view from previous page showing detail
of bolt-on brackets for short-bed trucks ONLY.
This slot not used on
short-bed trucks.
*4 *5
(not shown)
Universal bolt-on
bracket, use on
short-bed only.
Typical both sides
Sheet 2 of 9

Part Numbers:

Trim plastic if needed in area
shown on short bed trucks
Picture 1.
Plastic spare tire shield
*6
between bottom of
thru frame, block
41950N 3-27-15
Form: F205 Rev A 5-6-05
41950
Figure 2.
9/16" Heavy
flat washer
supplied.
Use if
needed on
top of block
between
frame and
hitch.
Insert block
frame and top of
bolt-on bracket.
Drop bolt down
and bracket.
Rev. A