Servicing Flush Tower - Toto CST436 Manual De Instrucciones Y Del Propietario

1. Turn off water supply and flush the toilet.
2. Remove the tank lid and place it upside down on a clean surface.
3. Note the orientation of the flush tower for reassembly.
4. Rotate the upper half of the flush tower so the arrow points towards
the overflow tube and pull it up to remove it (ill. 1)
5. Remove the rubber seal gasket and rinse under running water to clean
(see Ill. 2).
6. Place the gasket back on the flush tower (Ill. 3).
7. Align arrow with the overflow tube and install the flush tower back on
the base.
8. Rotate the flush tower to the same orientation (step 3).
9. Carefully, install the tank lid back on the tank.
10. Flush the toilet several times to verify proper operation. Check for
leakage.
ill.1
SERVICING THE FLUSH TOWER
ill.2
10
ill.3