QSC CXD Guia De Inicio Rapido página 5

XD Amplifier Signal Flow
Input Settings
Sensitivity
A/D Meter
Switch
Sensitivity
A/D Meter
Switch
Sensitivity
A/D Meter
Switch
Sensitivity
A/D Meter
Switch
Menu Tree
Presets
Preset Recall
Preset Save
Preset Wizard
*For QSC Line Arrays only.
A Power On
After connecting the outputs to the loudspeakers, you may turn the amplifier on.
1. Make sure all the audio source devices (CD players, mixers, instruments, etc.) are turned down fully.
2. Turn on the audio sources.
3. Turn on the AC mains power switch on the back of the amplifier. The amplifier starts up in the state it was in when power was removed. If the
amplifier is in Standby or Mute All mode (indicated by the power button LED solid or blinking red), press the power button to change the amplifier
to Run mode.
4. You can now turn up the audio sources.
High-pass
Gain Mixer Mute
Filter
High-pass
Gain Mixer Mute
Filter
High-pass
Gain Mixer Mute
Filter
High-pass
Gain Mixer Mute
Filter
Button
Activated
— Figure 11 —
Inputs
Input Sensitivity
Input Gain
Output Processing
Gain / Low-pass 5-Band
Delay
Polarity
Filter PEQ
Low-pass 5-Band
Gain /
Delay
Polarity
Filter PEQ
Gain / Low-pass 5-Band
Delay
Polarity
Filter PEQ
Low-pass 5-Band
Gain /
Delay
Polarity
Filter PEQ
Crossover
Outputs
Mixer w/Noise & Tone
Mode (Lo-Z, 70V, 100V)
Spkr Processing
Crossover
PEQ
Delay
Limiter
Array Correction*
Load Speaker
Save Speaker
5
Amp Config.
RMS /
A
Peak D / A Meter
Limiter
RMS /
B
Peak D / A
Meter
Limiter
RMS /
D
Peak D / A Meter
Limiter
RMS /
E
Peak D / A
Meter
Limiter
Set by Preset or Wizard
Atilities
Status
Amp ID
Display
Lockout
Password
GPI
GPO
TD-000350-00-E
EN