Kohler Vanity K-2451 Manual De Instrucciones página 4

Top of Door
Side of Vanity
Bracket
Latch
Hinge Base
Adjustments
Side
Remove/Adjust the Door(s) and Hinges
Door(s)
Removal:
Hold the door in place with one hand while releasing the latch
from the bracket at each hinge assembly location on the door. The
door will detach from the hinges. Set the door aside.
If applicable, remove the remaining door in the same manner.
Replacement/Reinstallation:
Line up the latch pin on the hinge cup with the groove on the
hinge base, then snap into place.
Open and close the door to confirm smooth operation. Adjust the
screws on the hinge assembly as needed.
Adjustment:
NOTE: Refer to the hinge assembly illustration above to select the
screw that corresponds to the adjustment needed.
Height - to move the door up or down - Turn the screw either
way on the bottom and top hinge assembly until proper
adjustment is achieved.
Side - to move the door to the left or to the right - Turn the
screw (specified in the illustration) either way on the assembly
until proper adjustment is achieved.
1049900-5-D
Hinge Cup
Slot
Cover Plate
Tab
Depth Height
4 Kohler Co.