Sauder Shoal Creek 409714 Manual Del Usuario página 12

Step 7
Diagram 1. Measure 1-1/2" from one end of the INTERLOCK TRACK (JJ). Position the INTERLOCK TRACK as shown.
å
ACTUATOR / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (JJ) into the CABINET ACTUATOR (GG).
å
Diagram 3. Rotate the INTERLOCK TRACK and apply force to snap the second edge into the CABINET ACTUATOR.
å
Diagram 4. Repeat the ACTUATOR / TRACK ATTACHMENT for the next CABINET ACTUATOR while holding the
å
previously completed CABINET ACTUATOR in its location hole. Repeat these steps until all ACTUATORS have been
attached. Visually check that all INTERLOCK TRACK edges have been snapped into the CABINET ACTUATORS as
shown in diagram 3.
Diagram 5. Remove the INTERLOCK TRACK assembly from Diagram 4 and fl ip it over before inserting the
å
INTERLOCK TRACK (JJ) with CABINET ACTUATORS (GG) into the groove in the RIGHT END (A).
STOP
Be sure the
interloack track
snaps into each
cabinet actuator.
GG
A
Page 12
The interlock system is a safety feature that prevents
more than one drawer from opening at the same
time. Do not use excessive force to open the drawers.
A
JJ
JJ
4.
2.
409714
1.
JJ
GG
JJ
3.
GG
www.sauder.com/services