Tabla de contenido
Publicidad
Step 9
Fasten the LEFT END (B) to the TOP (C). Tighten two
å
TWIST-LOCK® FASTENERS.
Fasten four METAL BRACKETS (AA) to the BACK (E). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (PP).
NOTE: Be sure the METAL BRACKETS are even with the
å
edge of the BACK.
Fasten the BACK (E) to the LEFT END (B). Use two BLACK
å
9/16" LARGE HEAD SCREWS (PP) through the METAL
BRACKETS and into the LEFT END.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
AA
Page 14
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
S u
r f a
w i t
h h
B
E
AA
409714
Finished edge
c e
o l e
s
C
The six holes on
other surface should
be located here.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
®
FASTENER
Dowel end
PP
www.sauder.com/services
Publicidad
Tabla de contenido
