Tabla de contenido
Publicidad
Step 12
The tabs should insert freely into the
1
slots. Gently tilt the DRAWER SIDES side
to side until the tabs slip into the slots.
D132
Groove
Insert the LARGE DRAWER SIDES (D132 and D138)
å
at an angle into the slot at each end of the LARGE
DRAWER FRONT (O2).
3
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (F2) to the LARGE
å
DRAWER FRONT (O2). Tighten one HIDDEN CAM.
www.sauder.com/services
D138
O2
Maximum
210 degrees
Minimum
190 degrees
F2
O2
VIEW THE T-LOCK BOX VIDEO
With the palm of your hand, tap the
2
DRAWER BOTTOM down into the groove.
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D983) into the grooves
å
in the LARGE DRAWER SIDES (D132 and D138) and
LARGE DRAWER FRONT (O2).
4
Arrow
D132
Fasten the LARGE DRAWER BACK (D175) to the LARGE
å
DRAWER SIDES (D132 and D138) and DRAWER
BRACE (F2). Use five BLACK 1-9/16" FLAT HEAD
SCREWS (30S). Repeat this step for the other large drawers.
The smaller drawer will use DRAWER FRONT (J2), DRAWER
SIDES (D10 and D11), and DRAWER BACK (D174).
409714
U n
fi n
s u
i s h
r f a
e d
c e
D983
D132
O2
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(20 used in this step)
D175
F2
D138
D138
30S
Page 17
Publicidad
Tabla de contenido
