Sauder Shoal Creek 409714 Manual Del Usuario página 16

Step 11
Fasten the RIGHT END (A) to the TOP (C) and BOTTOMS (D) as
å
shown in the upper diagram. Tighten four TWIST-LOCK® FASTENERS.
NOTE: Be sure the METAL PINS in the BOTTOMS insert into the holes
å
in the RIGHT END.
Fasten the RIGHT END (A) to the BACK (E). Use two BLACK 9/16" LARGE HEAD
å
SCREWS (PP) through the METAL BRACKETS and into the RIGHT END.
Carefully turn your unit over onto its front edges. Lay the LARGE
å
BACK (VV) over your unit as shown in the lower diagram.
Fasten the bottom edge of the LARGE BACK (VV) to the
å
BACK (E). Use six BLACK 9/16" LARGE HEAD SCREWS (PP).
Fasten the top and side edges of the LARGE
å
BACK (VV) to your unit using the NAILS (UU).
Use two BLACK 9/16" LARGE HEAD
SCREWS (PP) through the BRACKETS on
the BACK (E) and into the RIGHT END (A).
Page 16
VV
E
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
D
E
D
409714
C
A
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
UU
NAIL
(16 used in this step)
www.sauder.com/services
PP