Black 1-9/16" Flat Head Screw - Sauder 415107 Manual Del Usuario

Step 16
1
D132
Groove
Insert the DRAWER SIDES (D132 and D138) at an angle
å
into the slot at each end of the DRAWER FRONT (L).
3
M65
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M65) to the DRAWER
å
FRONT (L). Tighten one HIDDEN CAM.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D138
L
Maximum
Arrow
210 degrees
Minimum
190 degrees
L
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
i s h
r f a
e d
c e
D132
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (B36) into the
å
grooves in the DRAWER SIDES (D132 and D138) and
DRAWER FRONT (L).
4
Start each screw a few turns before
completely tightening any of them.

BLACK 1-9/16" FLAT HEAD SCREW

D183
D132
M65
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the DRAWER BACK (D183) to the DRAWER
å
SIDES (D132 and D138) and DRAWER BRACE (M65).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
415107
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
B36
L
D138
30S
(5 used in this step)
D138
Page 21