Residual Risks; Important Safety Instructions For All Battery Chargers - BTI Proline A-KS 18V Instrucciones De Manejo

thicker than the body of the blade but thinner than
the tooth set of the blade.
b) Adjust the riving knife as described in this
instruction manual. Incorrect spacing, positioning
and alignment can make the riving knife ineffective
in preventing kickback.
c) For the riving knife to work, it must be engaged
in the work piece. The riving knife is ineffective in
preventing kickback during short cuts.
d) Do not operate the saw if riving knife is bent.
Even a light interference can slow the closing rate
of a guard.

Residual risks

The following risks are inherent to the use of circular
saws.
– Injuries caused by touching the rotating parts or
hot part of the tool.
In spite of the application of the relevant safety
regulations and the implementation of safety devices,
certain residual risks cannot be avoided. These are:
– Impairment of hearing.
– Risk of squeezing fi ngers when changing the
accessory.
– Health hazards caused by breathing dust
developed when working in wood.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Maximum cutting depth.
DATE CODE POSITION
Date Code, which also includes the year of
manufacture, is printed into the housing surface that
forms the mounting joint between tool and battery!
Example:
2009 XX XX
Year of Manufacture
Important Safety Instructions for All
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains
All manuals and user guides at all-guides.com
important safety and operating instruc tions for the
15881/9023348 battery chargers.
•
•
•
•
•
•
•
•
49
Before using charger, read all instructions and
cautionary markings on charger, battery pack, and
product using battery pack.
DANGER: Electrocution hazard.
230 volts are present at charging terminals.
Do not probe with conductive objects. Electric
shock or electrocution may result.
WARNING: Shock hazard. Do not allow any
liquid to get inside charger. Electric shock
may result.
WARNING: Burn hazard. To reduce the risk of
injury, charge only BTI rechargeable batteries.
Other types of batteries may burst causing
personal injury and damage.
CAUTION: Under certain conditions, with the
charger plugged in to the power supply, the
exposed charging contacts inside the charger
can be shorted by foreign material. Foreign
materials of a conductive nature such as, but
not limited to, steel wool, aluminum foil, or any
buildup of metallic particles should be kept
away from charger cavities. Always unplug the
charger from the power supply when there is
no battery pack in the cavity. Unplug charger
before attempting to clean.
DO NOT attempt to charge the battery pack
with any chargers other than the ones in
this manual. The charger and battery pack are
specifi cally designed to work together.
These chargers are not intended for any uses
other than charging BTI rechargeable batteries.
Any other uses may result in risk of fi re, electric
shock or electrocution.
Do not expose charger to rain or snow.
Pull by plug rather than cord when
disconnecting charger. This will reduce risk of
damage to electric plug and cord.
Make sure that cord is located so that it will
not be stepped on, tripped over, or otherwise
subjected to damage or stress.
Do not use an extension cord unless it is
absolutely necessary. Use of improper extension
cord could result in risk of fi re, electric shock, or
electrocution.
Do not place any object on top of charger
or place the charger on a soft surface that
might block the ventilation slots and result in
excessive internal heat. Place the charger in
a position away from any heat source. The charger
is ventilated through slots in the top and the bottom
of the housing.
E N G L I S H