KTM Power Parts 28532900000 Guia De Inicio Rapido página 19

- Put the motorcycle into neutral.
- Start the engine and warm it up.
Rubber band method:
- Wrap the rubber band supplied around the outer end of the
handlebar grip and attach to the end of the clutch lever.
- While in neutral and at idle speed, accelerate the engine
quickly to at least 5,000 rpm and return to idle speed.
The clutch lever should move about 3 mm towards the
handle bar when the engine accelerates.
Manual method:
- Put the motorcycle into neutral and apply slight pressure to
the clutch lever while at idle speed.
- Accelerate the engine to at least 5,000 rpm.
Under slight pressure, the clutch lever should move about
3 mm towards the handlebar when the engine accelerates
and the centrifugal clutch engages.
- The check can be done before each trip.
- If the check was successful, proceed to the "Running in"
section.
Too much play?
Turn adjusting screw clockwise to increase the gap.
Insuffi cient play?
Turn adjusting screw counterclockwise to decrease the gap.
Running in procedure KTM & HQV
- Start motorcycle and in idle (position N) rev up the engine 10
times to approx. 5000 rpm, without operating the clutch lever
while doing so.
- Make sure that the engine returns to idle between each rpm
cycle.
19