Kit Assembly - Metra 99-8160G Instrucciones De Instalación

ISO DIN radio provision
1. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
2. Mount the bracket/pocket
assembly to the radio housing with
the included (4) #8 x 3/8" screws.
(Figure B)
3. Mount the two panel clip brackets
to the brackets using the supplied
(4) #4 x 3/8" screws. (Figure C)
4. Attach the (2) white plastic panel
clips to the panel clip brackets.
(Figure C)

Kit Assembly

(Figure A)
(Figure B)
99-8160G
5. Slide the radio into radio brackets
and secure with screws supplied
with the radio. (Figure D)
6. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
Note: The factory antenna
connection is located at the tuner
brain on the passenger side rear
of the trunk and will need to be
routed through the vehicle to
connect with the aftermarket radio.
7. Mount the new radio assembly into
the dash and reassemble dash in
reverse order of disassembly.
3
(Figure C)
(Figure D)