Possible Faults - Mowox RM 30 Li Instrucciones De Funcionamiento Originales

Possible faults

problem
Robot
doesn't start
from the
station on
your
command
Robot
switches off
instead of
heading out
for cutting.
robotic
mower
stopped in
the working
area
robotic
mower
stopped in
the working
area
robotic mower
tumbled and
stopped
Rev 19
message on possible reason
the LED
Battery LED Empty battery.
flashing red
Battery LED If the battery voltage is
red steadily too low and the battery
is not connected to the
charging station, the
mower stops the
operation and the
display turns off.
Error LED The robotic mower is
red steadily trapped and stopped;
this occurs when the
collision sensor has
been triggered more
than 10 times within 1
minute.
Battery LED The robotic mower has
red steadily been lifted
continuously for ten
seconds.
Error LED The robotic mower has
blue flashing rolled over (upside
down) or lifted > 35%
(20°).
action
Let battery recharge in the home
station.
Carry the robotic mower to the
charging station.
1. Check if the robotic mower is
trapped by an obstacle or jammed
between trees bushes etc. Remove the
obstacle or avoid this area.
2. Check if the grass in the lawn is too
tall to block the Robotic mower on
moving. If so, please cut the grass to
less than 60 mm
3. Restart the robotic mower or take it
back to the charging station.
4. If this error message shows up
often, please check if the boundary
wire is correctly laid. Especially check
narrow corners, corridors, fences,
rocks, surrounding etc. Please change
the boundary wire layout.
Check if there are obstacles lower than
100 mm in the working area and, if
needed, move those out of the
working area or change the boundary
wire layout to exclude those.
1. If the roll-over is caused by too stiff
slopes in the working area, please
correct the boundary wire layout to
avoid those.
2. Take the robotic mower to a flat
area and restart it.
36 (EN)