Possible Faults - Mowox RM 750 BTU-SN Manual De Instrucciones

cable.

Possible faults

problem message on
the LED
Robot Battery LED
doesn't start flashing red
from the
station.
Robot Battery LED
switches off red steadily
instead of
heading out
for cutting.
robotic Error LED
mower blue stead-
stopped ily
robotic Error LED
mower red steadily
stopped
robotic Error LED
mower tum- flashes red
bled and (1 / second)
stopped
possible reason
Empty battery.
If the battery voltage is
too low and the battery
is not connected to the
charging station, the
mower stops the oper-
ation and the display
turns off.
The robotic mower is
trapped and stopped;
this occurs when the
collision sensor has
been triggered more
than 10 times within 1
minute.
The robotic mower has
been lifted continu-
ously for ten seconds.
This can also happen
when it climbs onto an
obstacle with the chas-
sis and the front wheels
lose ground contact.
The robotic mower has
rolled over (upside
down) or lifted > 35%
(20°).
42 (EN)
action
Let battery recharge in the home sta-
tion.
Carry the robotic mower to the charg-
ing station.
1. Check if the robotic mower is
trapped by an obstacle or jammed be-
tween trees bushes etc. Remove the
obstacle or avoid this area.
2. Check if the grass in the lawn is too
tall to block the Robotic mower on
moving. If so, please cut the grass to
less than 60 mm
3. Restart the robotic mower or take it
back to the charging station.
4. If this error message shows up of-
ten, please check if the boundary wire
is correctly laid. Especially check nar-
row corners, corridors, fences, rocks,
surrounding etc. Please change the
boundary wire layout.
Check if there are obstacles or deep
pot holes (< 35 mm) in the working
area and, if needed, move those out of
the working area or change the
boundary wire layout to exclude
those.
1. If the roll-over is caused by too stiff
slopes in the working area, please
correct the boundary wire layout to
avoid those.
2. Take the robotic mower to a flat
area and restart it.