Care And Maintenance; Troubleshooting; Corrective Action - Harbor Breeze E-YLM52WW5C1 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CARE AND MAINTENANCE

At least twice each year, lower canopy (B) to check downrod (A) assembly, and then tighten all
screws on the fan. Clean motor housing (D) with only a soft brush or lint-free cloth to avoid
scratching the finish. Clean blades (G) with a lint-free cloth. You may occasionally apply a light
coat of furniture polish to wood blades for added protection.
IMPORTANT: Shut off main power supply before beginning any maintenance. Do not use water
or a damp cloth to clean the ceiling fan.

TROUBLESHOOTING

WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not
move.
Noisy operation.
Excessive
wobbling.
POSSIBLE CAUSE
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
4. Wires in light kit fitter not wired
correctly.
1. Blades are loose.
2. Cracked blade.
3. Fan is new.
1. Blades are loose.
2. Blade arms incorrectly attached.
3. Unbalanced blades.
4. Fan not securely mounted.
5. Fan too close to vaulted ceiling.
6. Set screw(s) on motor housing yoke
is (are) not tightened properly.
7. Set screw on hanging ball is not
tightened properly.

CORRECTIVE ACTION

1. Push switch firmly either up or
down.
2. Turn power on or check fuse.
3. Turn power off. Loosen canopy
and check all connections.
4. Check that molex connections in
light kit fitter are connected
properly according to instructions
on page 14.
1. Check Three-C clips.
2. Replace blade.
3. Allow fan a "break in" period of a
few days, especially when
running the fan at Medium and
High speeds.
1. Check Three-C clips.
2. Re-install blade arms, according
to instructions on page 13.
3. Switch one blade with a blade
from the opposite side or use
balancing kit (X).
4. Turn power off. Carefully loosen
canopy and verify that mounting
bracket is secure.
5. Use a longer downrod or move
fan to another location.
6. Tighten yoke set screw(s)
securely.
7. Carefully loosen and lower
canopy and verify that set screw
on hanging ball is tightened
securely.
Lowes.com/harborbreeze
17

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

0593743

Tabla de contenido