Safety Instructions; Inspection And Maintenance - KBT curve Modo De Empleo

INSTRUCTIONS FOR USE

SAFETY INSTRUCTIONS

1. Please keep this instruction sheet safely for future reference.
2. Inappropriate use or faulty application of the product are explicitly forbidden and absolve the manufacturer of
all liability.
3. The use of the item is allowed only under continuous supervision by an adult. This product is suitable for in-
dividuals weighing up to 30 kg.
4. This product meets all security aspects of the European standards EN1176-1&22017. This product is fit for use
in commercial playgrounds, both indoor and outdoor.
5. The application of the item as part of a playframe or any other construction will have to be such that it ex-
cludes all risks of entrapment.
6. Use swing hooks type 817.004 or 817.006 and a minimum beam thickness of 120 mm to attach these swing
hooks to.
7. The minimum distance from (the bottom of) the swing seat (when not in use) to the ground surface should be
35 cm.
8. The distance between the attachment points to the beam equals the distance between the chains at the
bottom of the seat, plus 5% of the chain length.
9. The minimum distance between the swing seats should be 20% of the chain length plus 30 cm.
10. The minimum distance between the swing seat and the frame should be 20% of the chain length plus 20 cm.
11. The critical free fall height equals the length of the chains divided by 2, plus the height of the swing seat at
rest.
12. When mounting or assembling the product, attention should be given that the impact area has the minimum
required distance between the product and eventual obstacles: walls, fencing,... The free falling space should
be like specified by the grey area as shown drawing FIG I.
13. In these safety areas no hard, angular or pointed objects should be present. The safety surface underneath
the product must be flat, and be covered in a suitable way (eg. rubber tiles, bark, wood chips). The product
must not be placed on asphalt, concrete or any other hard surface. There cannot be an overlapping of sur-
rounding free spaces or safety areas.
14. Swing frames or their top bar should only be attached to other equipment where specific measures are taken
to segregare them from other activities. For example: an additional 150 cm free space, barriers, ...

INSPECTION AND MAINTENANCE

The frequency of inspection and maintenance will vary with the type of equipment or materials used or other
factors (e.g. heavy use, levels of vandalism, coastal location, air pollution, age of equipment, ...). Moving metal
parts must be oiled regularly.
Routine visual inspection (weekly to monthly)
- Always check that the bolts and nuts are securely fastened.
- Check the shock absorbing surface for objects that don't belong there.
- Check for missing parts.
- Check the equipment ground clearances.
Operational inspection (1 to 3 months)
- Check the stability of the construction.
- Check every part for excessive wear and replace when necessary.
Annual inspection (1 to 2 times per year)
- Check for rust and corrosion.
- Check every part for excessive wear and replace when necessary.
2
TOOLS
(1) (2)
13
5
(1) ratchet spanner with cap 13
(2) allen key 5 mm
(3) allen key 6 mm
baby seat 'curve'
(3)
6
EN