Setting/Activating The Alarm (Alarm 1 / Alarm 2) - Medion LIFE P66120 Manual De Instrucciones

11.2. Setting/activating the alarm (ALARM 1 / ALARM
2)
The device has two alarm functions, using either an alarm tone or the radio as a
wake-up call.
 In radio mode, press and hold the MENU button until SET MENU appears
on the display. Use the  or  buttons to select the ALARM 1 SET sub-
menu.
 Press the ENTER button to navigate to the ALARM 1 SET or ALARM 2
SET menu.
ALARM 1 / ALARM 2
− Activate ALARM 1 / ALARM 2 with the  or  (ON) buttons and
confirm with ENTER.
SET ALARM TIME
− Use the  or  buttons to set the hour (HOUR) and confirm with EN-
TER.
− Use the  or  buttons to set the minute (MIN) and confirm with EN-
TER.
SET ALARM VOL
− Use the  or  buttons to set the alarm tone (VOL) and confirm with
ENTER.
SET ALARM SRC
− Under SRC use the  or  buttons to select the type of alarm tone
(ALARM, DAB or FM) and confirm with ENTER.
SET ALARM MODE
− Under MODE use the  or  buttons to set the mode (DAILY (daily),
WEEKENDS (only at weekends), WEEKDAYS (only on weekdays) or
ONCE (once)) and confirm with ENTER. After this you will then auto-
matically exit the SET MENU menu.
 Press the -VOL.+ controller to interrupt the alarm signal. Pressing again
causes the alarm to continue.
 Pressing the ENTER button during the alarm activates the snooze function.
The alarm is interrupted and sounds again after approx. 10 minutes.
 Press the MODE button during the alarm to stop the alarm.
176