Harbor Breeze BRD48BNK6LRS Manual Del Usuario página 12

WIRNG
1. Make the necessary wiring connections for remote
control operation as detailed below and in the
accompanying drawing. To make wire connections,
use wire connectors (AA) in hardware pack and wire
connectors in remote pack (P), making sure to
screw each wire connector on in a clockwise
direction.
CAUTION: Assistance from another person is
recommended for this step.
Hardware Used
AA Wire Connector
Connect all GROUND (GREEN) wires from fan (on
downrod (A), if applicable, and mounting bracket
(C)) to BARE/GREEN supply wire from ceiling.
Connect BLACK wire (labeled AC IN L) from
remote control receiver (Q) to BLACK supply wire
from ceiling.
Connect WHITE wire (labeled AC IN N) from remote
control receiver (Q) to WHITE supply wire from
ceiling.
Connect WHITE wire (labeled TO MOTOR N) from
remote control receiver (Q) to WHITE wire from
motor housing (D).
Connect BLACK wire (labeled TO MOTOR L) from
remote control receiver (Q) to BLACK wire from
motor housing (D).
Connect BLUE wire (labeled FOR LIGHT) from
remote control receiver (Q) to BLUE wire from
motor housing (D).
x 3
1
WHITE SUPPLY WIRE
BLACK SUPPLY WIRE
BLUE
WHITE
FROM
FAN
FROM
RECEIVER
BLUE
12
GROUND (GREEN OR BARE)
AA
BLACK
C
AA
A
BLACK
WHITE
AC IN N
WHITE
Q
GROUND
(GREEN
OR BARE)
WHITE
BLACK
FROM
CEILING
AA
FROM
RECEIVER
BLACK
AC IN L