Final Installation - Harbor Breeze BRD48BNK6LRS Manual Del Usuario

FINAL INSTALLATION

1. Temporarily lift canopy (B) to mounting bracket (C) to
determine which two canopy mounting screws/lock
washers (K) in mounting bracket (C) align with slotted
holes in canopy (B) and partially loosen these two
canopy mounting screws/lock washers (K). Remove the
other two canopy mounting screws/lock washers (K).
Now, lift canopy (B) to mounting bracket (C) again,
aligning slotted holes in canopy (B) with loosened
canopy mounting screws/lock washers (K) in mounting
bracket (C). Twist canopy (B) to lock. Re-insert the two
canopy mounting screws/lock washers (K) that were
just removed and tighten all canopy mounting
screws/lock washers (K) securely.
2.
DANGER: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades (G). If screws are overtightened, blades (G)
may crack and break.
Partially insert three blade screws (CC) along with
three fiber blade washers (BB) into holes in blade (G)
to attach blade arm (J) to blade (G). Then, tighten
each blade screw (CC) starting with the one in the
middle. Repeat with remaining blades (G).
Hardware Used
Fiber Blade Washer
BB
Blade Screw
CC
3. Insert two motor screws/lock washers (DD) through
one blade arm (J) to attach blade arm (J) to motor
housing (D). Tighten motor screws/lock washers (DD)
securely. Repeat with remaining blade arms (J),
making sure to completely secure each blade arm (J)
before proceeding with the next.
Hardware Used
Motor Screw
DD
/Lock Washer
1
2
x 18
x 18
3
x 12
DD
DD
14
K
K
B
CC
BB
G
J
D
G
J