Silverline 128965 Manual Del Usuario página 7

128965
7. Always disconnect the machine from the power supply before leaving
it unattended
Accessories
• A range of accessories and consumables, including 40 Grit Sanding
Belts 75 x 533mm 5pk (391857), 120 Grit Sanding Belts 75 x 533
5pk (625574) and Sanding Belt Cleaning Block (224688) is available
from your Silverline stockist. Spare parts can be obtained from
toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying
out any inspection, maintenance or cleaning.
Drive belt replacement
• A spare drive belt is supplied with this tool. If the drive belt needs to be
replaced:
1. Place the sander on its side, with the Drive Belt Housing Cover (5) facing
upwards
2. Remove the two screws securing the Drive Belt Housing Cover, and
remove the cover to reveal the drive belt and gears
3. Remove the old drive belt and fit the new drive belt by looping it over the
larger gear, then onto the smaller gear. Ensuring the teeth sit within the
grooves on the gears
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Silverline service centre.
This advice also applies to extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts
to wear quickly, and shorten the machine's service life. Clean the body of
your machine with a soft brush, or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do
not use alcohol, petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable
spray lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised Silverline service centre
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
www.silverlinetools.com
950W Belt Sander
7