Installation; Voltage Stabilizers; Electrical Connection - Vestfrost VLS 064A RF AC Instrucciones Para El Uso

Voltage stabilizers

It is highly recommended that all cold chain
equipment running on AC current is installed
with a voltage stabilizer, in order to safeguard
the equipment against voltage fluctuations.
Stabilizers should be selected & installed as
per the input
voltage available.
Instructions to User:
● Every refrigeration unit must be connected
to an individual stabilizer.
● Bypassing of Stabilizer is not recommend-
ed, as such practice may lead to damage
of the CCE & in turn safety of vaccines &
hence must be avoided.
● Proper earthing should be available and
connected.
● Emphasize on repairing stabilizers immedi-
ately. Identify authorized Vestfrost service
provider in case of technical assistance is
required.
The voltage stabilizer is also provided with ar-
rangement to cut off its output voltage to the
lLR in case the mains voltage goes below or
above as per designed input voltage range.
The output is restored automatically after the
factory set delay 3 to 6 minutes (WHO/PQS
E007/VS01.4 specifications) when the mains
voltage is within the recommended range and
remains within.

Electrical connection

Wiring and connections in power supply
systems must been all applicable (local and
national) electrical codes. Consult these
codes lengths and sizes prior to cabinet

installation.

This device complies with relevant EU
directives including Low Voltage Directive
2014/35/EU and Electromagnetic Compat-
ibility Directive 2014/30/EU
The socket should be freely accessible.
Information regarding voltage, current or
power are given on the rating plate
The power cord may be replaced by a
technician only.
Check that the plug fits your type of socket.
If it does not fit, have a qualified electri-
cian to fit the plug. This appliance must be
earthed.
Connect the appliance to voltage stabi-
lizer and connect voltage stabilizer to wall
socket. (Fig 6 + 7)
Fig. 6
7
GB
Fig. 7