TOPP DS2 Instrucciones Para La Instalación Y El Empleo página 18

Selector de programa digital
Tabla de contenido

Publicidad

Digital program switch menu
EN
14
OTHER
: Allows you to number the doors connected from
NUMBERING
1 to 4 *
To exit from the DOOR NUMBERING press
*Doors numbering: (if it has not been done before, this
procedure is accessible also from the home screen by pressing
' arrow down ' for 4sec in case of communication error)
To program:
1.Enter the number of the connected doors
2.Press, one by one, the 'ENTER' key on the correspondent
door's motor board.
The doors must be connected as shown (see fig. No.10). The
wires to be connected are GND (2), Serial A (3) and Serial B (5).
In case of lengths in excess of 20m we recommend using a
shielded type cable.
: Allows you to select the language between:
LANGUAGE
italian
english
french
spanish
RADIO
ACQUIRE
: Allows you to add up to 8 radiocontrols. Possibility of installation only
with a motor board equipped with optional radio module.
DELETE
: Allows you to eliminate all the
radiocontrols
To program the radio control devices (up to 8):
- If you are using the remote radio control kit, Top TR8, press the
smooth part of the first key (Open Function)
- If you are using the Topp TS1 4-channel remote control, press
the second key (Close Function).
: Allows you to change the default expert password
EX PASSWORD
(default 2426 )
The password remains active for 1 minute once out of the menu,
then it has to be inserted once again.
DIAGNOSTIC
ENTRÉES
: Visualise toutes les entrées radar entrées int. et externes :
sécurité V.P et latérales, clé, bouton d'urgence et
anti-incendie, anti-panique
SORTIES
CODEUR
HISTORIQUE ERREURS
: affiche les 8 dernières erreurs avec la date et l'heure.
Voir le tableau erreurs.
MODÈLE
SW DOOR
DATA SW
SW DS2
DATA SW
Temp. Moteur
Diagnostic
EN
:Permet d'activer les sorties suivantes :
électroverrouillages, lames d'air et lampe
:Permet en outre de visualiser la position
du codeur
PARAMETERS
OTHER
AUTOM. RECLOSING
PARAMETERS
TIME
PARTIAL RECLOSING
TIME.
AUTO.RECL.TIME
CLOSING SEAL
SAFETY SENSOR LOGIC
PARTIAL OPENING.
EB1 LOGIC
EB1 MODE
EB2 LOGIC
PHARMACY
PHARMACY OPEN
EMERGENCY LOGIC
ANTIPANIC LOGIC
: Battery operation mode:
BATTERY
NC: Battery not installed
AP: opens in case of power outage on mains
AC: opens except when in closed mode
ACUE: opens except when in closed mode, exit only, entry only, closes, pharmacy
CP: closed
CN: continuous operation
: YES ( possible to enable 2 pairs of doors 1-2 and 3-4 )
INTERLOCK
: NO
: Change the standard mode of operation of the Ts2, MS1 accessory
MODE 2
buttons.
Entry only:
if you have the TS2, MS1 control accessories
Wings free:
: allows use of MODE 2
if the automation board is set up for the «Wings free» function.
: automatic reclosing time.
Adjustable from 0 to 60 seconds.
: partial reclosing time.
Adjustable from 0 to 60 seconds.
: automatic reclosing time after key impulse
Adjustable from 0 to 60seconds
: Adjustable from 0 to 3 (disables closing seal, enables the
push&go function
: Safety sensor logic:
NOS: normally open without test
NCS: normally close without test
NC test : normally close with test
NO test: normally open with test
: adjustable from 5 to 95% of the door opening
: Electric lock logic 1:
OF: Disabled
CT: Block if powered
ST: Block if not powered
Eb6
: Electric lock mode 1 :
B1: Closed
B2: Closed,exit only,entry only
B3: Closed,exit only,open only,automatic
partial
SEE EB1 LOGICA
(Non available for T150-T240)
: enables or disables the pharmacy function
(Non available for T150-T240)
: pharmacy opening setting. Adjustable from 2 to 20cm.
Important: regulate in relation to the position of electric lock 2
(Non available for T150-T240)
:Setting emergency opening.
:N.O. Normally open
:N.C. Normally closed
: Setting antipanic opening.
:N.O. Normally open
:N.C. Normally closed
«Entry only», operates like «Entry only»
«Entry only», operates like «Wings free» ,
.
if you have the TS2, MS1 control accessories
18

Publicidad

Tabla de contenido
loading

Productos relacionados para TOPP DS2

Tabla de contenido