Klarstein 10031081 Manual Del Usuario página 14

Insert wire and safety wire through
the downrod set. Fit one end of the
downrod, with no ball attached, to
the top portion of the "U" tube. Put
the washer through the downrod
4
screw. Then put the washer and
spring washer through the downrod
screw at the other end. Then tighten
hex nut firmly and securely.
Loosen screws at the side of the
center of blades, push the blade into
5
the axle. Tighten the screws.
Adjust the angle into proper position, then tighten the screws.
6
14