Check if the mounting bracket is
properly and securely installed, then
7
place the assembled fan onto the
mounting bracket.
The ball at the top of the downrod
allows the fan to face six directions,
confirm a direction before placing
the ball onto the mounting bracket.
As shown in the diagram below.
Tighten the two downrod set screws
to make sure the fan run stably.
8
Then, install downrod (ball part)
into mounting bracket opening
that already securely fastened to a
structural ceiling member. The tab
opposite of the mounting bracket
opening should fit in slot on ball.
Make sure all wires are proper
9
connected.
15