Sauder 409047 Manual Del Usuario página 15

Step 10
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Turn two BLACK 9/16" LARGE HEAD SCREWS (1S) into the short
å
slots of the FOOT BRACKET (6E).
BLACK 9/16" LARGE HEAD SCREW
(2 used for the FOOT BRACKET)
www.sauder.com/services
F
6E
1S
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(33 used for the BACK)
These holes must line up
over the UPRIGHT (C).
409047
1N
NAIL
Page 15