Black 1-1/8" Machine Screw - Sauder 409047 Manual Del Usuario

Step 12
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the
å
diagram. If it isn't, loosen the mounting screw to slide it against the stops. Then, tighten the mounting screw.
Fasten a DOOR (G) to the LEFT END (B). Use the screws in the HINGES. See the next step for adjustments.
å
Fasten a BACKPLATE (18K) and KNOB (17K) to the DOOR (G). Use a BLACK 1-1/8" MACHINE SCREW (21S).
å
Peel the FELT DISC from the FELT DISC CARD (1M). Stick a FELT DISC on the DOOR where it comes in contact
å
with the UPRIGHT (C).
Repeat this step for the other door.
å
Apply the WARNING LABEL (2L ) to the TOP (D). You should be able to read the label when the TV is removed
å
from the unit. When the TV is in place, it should hide the label. Peel off the backing and apply the label as shown
in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
å
Hinge
17K
18K
G
1M
www.sauder.com/services
Stop
Mounting
screw
B
21S

BLACK 1-1/8" MACHINE SCREW

(2 used in this step)
Never use this furniture with a TV that is too
large or too heavy. Severe injury or death can
occur. The TV and furniture will be unstable
and may tip.
- The TV must weigh less than 70 lbs.
2L
- The base of the TV must be able to sit
completely on this shelf.
D
C
409047
WARNING
Page 17