UFESA CE7240 Manual De Instrucciones página 18

release the press bar, and you can fix them into coffee maker firmly through turn it anticlockwise until
it is at the "lock" position. (Fig. 1).
Pour out the hot water in the cup. Then place the hot cup on removable shelf.
At the time, the green lamp is illuminated, if the green lamp is extinguished, wait for a moment, once
the green lamp is illuminated, and you should press the coffee/hot water selector on the "1" position,
waiting for a moment, there will be coffee flowing out.
Note: During operation, if the green indicator is extinguished, you must close the pump and stop to
make espresso coffee. After a few seconds, if the green lamp is illuminated again, you can make
espresso coffee continued by pressing coffee/hot water selector to "1" position, the green lamp is cycle
ON and OFF to maintain the water temperature is hot enough.
You should press coffee/hot water selector to "0" position manually when desired coffee is obtained or
the colour of coffee changes weak obviously, the red and green indicator go out and the coffee maker
stops working, your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you need operate
manually sometimes!
After finishing making the coffee, you can take the metal funnel out through turn anticlockwise, and
then pour the coffee residue out with the steel mesh pressed by press bar.
Let them cool down completely, then rinse under running water.
FROTHING MILK/ MAKING CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Method:
Prepare espresso first with container big enough according to the part "MAKE ESPRESSO COFFEE",
make sure that the steam control knob is at the "OFF" or "0" position.
Press steam+switch button, wait for a moment, until the steam+switch indication light change from
flashing from to keeps on.
Note: During operation, if the green indicator is extinguished, you should turn the steam control knob
to "OFF" or "0" position. Press coffee/hot water selector to the "1" position and pump water, after
about 30s, close the pump coffee/hot water selector to the "0" position), then wait for until the green
indicator is illuminated and turn the steam control knob in anticlockwise, the steam will come out
again.
Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are recommended to
use whole milk at refrigerator or room temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
Turn the steam control knob slowly in anti-clockwise, steam will come out from the frothing device.
Note: Never turn the steam control button rapidly, as the steam will accumulate rapidly in short time
which may increase the potential of the risk of explosion.
Insert the frothing device into the milk about two centimetre, froth milk in the way moving vessel round
from up to down.
When the required purpose is reached, you can turn the steam control knob to "OFF" or "0" position.
Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not to
hurt!
18