Making Hot Water - UFESA CE7240 Manual De Instrucciones

Pour the frothed milk into the espresso prepared; now the cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
Press the ON/OFF switch to the "0" position to cut the power source off.
Note: we recommend you allow the maker to cool down at least for 5 min before making coffee again.
Otherwise burnt odor may occur in your Espresso coffee.

MAKING HOT WATER:

1. With this function, you can pre-heat your coffee cup to ensure that the temperature of the coffee will
not decrease. So as to improve the coffee flavor.
2. Clean your coffee cup. After drinking coffee, you can directly make hot water with this coffee maker
to clean the cups. This makes it more simple and convenient to clean the cups.
Methods:
1. Press the On/Off switch to the "1" position; the Steam switch to "0" position, Coffee/hot water
selector to "0" position. The red lamp will be illuminated; waiting for a moment, the green lamp will
be illuminated.
2. First, turn the steam control knob from "OFF" to "0" position in anti-clockwise. (Turn the knob with
at least 135 degree.) Then press coffee/hot water selector to "1" position, and hot water will flow out
from the steam wand.
Note: At first the hot water will scatter from the steam wand. May let the steam wand outlet close to
the coffee cup wall. Thus at this moment, you need to pay attention to the protection of hot water
splash burns skin.
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothing device) can be used to make hot beverages like drinking
chocolate, water or tea.
Method:
Open the tank cover, remove the detachable tank and fill it with desired water, the water level should
not exceed the "MAX" mark in the tank. Then place the tank into the appliance properly.
Replace the tank, then connecting the appliance to power supply source.
Press the ON/OFF switch to the "1" position, the red lamp is illuminated.
Turn the steam control knob to "OFF" or "0" position, make the coffee/hot water selector on the "1"
position, the pump will pump water, when there is water flowing out, close the pump (coffee/hot water
selector to the "0" position) immediately, pressing the steam selector to the "1" position and waiting for
a moment, the appliance begins to be heated until the green lamp is illuminated, it shows the heating
is finish.
Remove the frothing device from the steam wand.
Dip the steam wand into the liquid to be heated. Turn the steam control knob in anti-clockwise slowly
to start making steam.
When the required temperature is reached, you can turn the steam control knob to "OFF" or "0" position.
Press the ON/OFF switch to the "0" position to cut the power source off.
19