WAGNER FINE COAT Manual Del Usario página 4

ATTACH SUCTION TUBE
Unscrew the paint container from the
gun. Push the long, tapered end of the
plastic suction tube with a firm, twisting
motion into the gun body.
If you are going to be spraying in a
downward direction the angled end of
the suction tube should be pointing to-
ward the front of the gun. If you are
going to be spraying in an upward direc-
tion the angled end of the suction tube
should be pointing toward the rear of
the gun. By pointing the suction tube in
the proper direction you will not have to
refill the container as often.
NOTE
There is a small vent hole in the cup
seal. This hole must be open to as-
sure proper paint flow. Be sure to
clean after each use.
SET-UP
ATTACH AIR HOSE
9Take the air hose and push one end
firmly into the large opening at the rear
of the spray gun. Insert the other end
of the hose into the turbine cover, align-
ing the tabs on the hose with the slots in
the fitting. Push the hose in and turn
clockwise 90° to lock the hose in place.
To remove the hose from the fitting, turn
90° counterclockwise to align the tabs
on the hose with the slots in the fitting
and pull out.
NOTE
Allow the hose to cool down before
attempting to remove from the tur-
bine and always grasp the hose by
the fitting to remove rather than by
the hose.
4