Adjust Spray Pattern - WAGNER FINE COAT Manual Del Usario

ADJUST SPRAY PATTERN

PATTERN SHAPE SELECTION:
The spray pattern shape is adjusted by
turning the ears of the air cap to either
the vertical, horizontal, or diagonal
positions. The positions of the air cap
and the corresponding spray pattern
shapes are illustrated below.
each pattern and use whichever pat-
tern is suitable for your application.
ROUND PATTERN
VERTICAL PATTERN
HORIZONTAL PATTERN
OPERATION
PATTERN SIZE ADJUSTMENTS:
If you want to change the size of your
spray pattern simply move closer to or
farther from your workpiece. In doing
so you may have to reduce your mate-
rial flow if you move closer to your
workpiece and increase your material
Test
flow if you move farther from your work-
piece. (See material flow adjustment).
The farther back from the workpiece the
greater the chance you will have some
over spray.
As long as the turbine is turned on
there will be a constant airflow out
the tip of the gun, this is normal. The
cup remains pressurized when the
turbine is turned off. Do not pull the
trigger on the gun unless the turbine
is turned on or the paint will squirt
out as a stream. To remove pressure
in the cup simply loosen by unscrew-
ing 1/2 turn.
Do not pull the turbine by the hose,
Use the handle on the top of the
turbine.
WARNING
NEVER TRIGGER GUN WHILE AD-
JUSTING THE EARS ON THE AIR
CAP.
Never point the spray gun at
any part of the body.
NOTE
6
MATERIAL FLOW ADJUSTMENTS:
To adjust the amount of material being
sprayed, turn the knob located on the
back of the gun and under the air hose
clockwise to decrease the amount of
paint or counterclockwise to increase
the the amount of paint being sprayed.
Each individual job and material may
require a slight adjustment to this
setting. For your individual needs
spray first on a test surface.
USING THE INFLATOR
NOZZLE
As an added feature of this system, a
nozzle is supplied which can be used to
inflate air mattresses and other types of
inflatables. To use the inflator nozzle,
attach one end of the air hose to the
nozzle and the other end to the turbine.
Next, insert the small end of the inflator
nozzle into the item to be inflated and
turn on the turbine. Be careful not to
over-inflate (will not inflate tires).