WAGNER FINE COAT Manual Del Usario página 8

EMPTY PAINT
CONTAINER
Pour the remaining paint from the
container back into the paint can after
use.
REASSEMBLE
Reassemble any parts that were disas-
sembled for cleaning. When replacing
the suction tube and paint container for
storage do not assemble too tightly.
During clean-up with certain solvents
the valve cup on the suction tube may
become wrinkled. Don't become
alarmed, it will regain it's shape in a
short time.
CLEAN-UP
SPRAY APPROPRIATE
CLEANER THROUGH GUN
Pour a small amount of the appropriate
solvent in the cup, attach cup to gun,
shake and spray solvent through the
gun in a safe area.
Repeat above step once or twice until
the cup is clean, then wipe exterior of
cup and gun clean.
Be sure to remove and clean the suc-
tion tube and sealing surfaces inside
the gun after each use.
8
DISASSEMBLE AND
CLEAN SMALL PARTS
Remove projector set, (nozzle, needle
& air cap) and clean with a soft brush
and solvent or by soaking for a short
period of time. Never use any metal
tools to pick at the air cap or fluid nozzle
holes.
Disassemble the needle from the gun
by unscrewing material adjustment
knob, removing the needle spring and
pulling the needle straight out the rear
of the gun.
Disassemble the fluid nozzle from the
gun by unscrewing the retaining ring,
removing the air cap and air flow
diverter, and unscrewing the fluid nozzle
with a 10 mm open end or adjustable
wrench.