Descargar Imprimir esta página

Mounting The Power Supply - KTM Power Parts 60112092140 Manual Del Usuario

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Scope of delivery:
1x preassembled retaining plate (1)
1x intermediate plate (2)
1x end plate (3)
3
4x screws M4x30
1
4x screws M5x16
4x nuts M4, self-locking
4x U washers (Alu)
4x U washers M4
4x distance sleeves, plastic
4x vibration damper disks
2
Preparations
Please read this manual in its entirety, paying particular attention to the instruc-
tions on opening and closing the holder.
6

Mounting the power supply

1
To mount the power supply of your TOMTOM Rider 2, you require retaining
plate (1), intermediate plate (2), the distance sleeves and the screws M5x16.
Connect the parts as follows: place retaining plate (1) onto intermediate plate
(2) and insert the four screws M5x16 from behind. Place the distance slee-
ves on the screws. (See figure).
2
Now use the four screws M5x16 to screw the power supply (A) onto the retai-
ning plate (max. 3Nm).
tighten the screws too tightly to ensure that the threaded sleeves in the power
supply unit are not pulled out.
A
To mount end plate (3), you require the remaining installation materials inclu-
ded in the package. Prepare by assembling the four screws M4x30 as shown
in Figure (B):
4
Screw (5), U washer Alu (6) and vibration damper disk (4).
5
6
B

Publicidad

loading