Tabla de contenido
Publicidad
Step 9
Step
1
D87
Groove
Insert the DRAWER SIDES (D87 and D88) at
å
an angle into the slot at each end of the UPPER
DRAWER FRONT (H3).
3
Fasten the DRAWER BACK (D61) to the DRAWER SIDES (D87 and D88). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D729) inserts into the groove of the DRAWER BACK (D61).
å
Repeat this step for the remaining drawer using the LOWER DRAWER FRONT (I3).
å
Page 14
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
H3
D88
D61
D87
D729
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
r f a
D87
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D729) into the grooves
å
in the DRAWER SIDES (D87 and D88) and UPPER
DRAWER FRONT (H3).
D88
102702
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
e d
c e
D729
H3
D88
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
www.sauder.com/services
Publicidad
Tabla de contenido
