Sauder Heritage Hill 102702 Manual De Instrucciones página 8

Step 3 Step
Diagram 1. Cut out and use the "spacer" at the top of this page to measure 2-1/2" from one end of the INTERLOCK
å
TRACK (T). Position the INTERLOCK TRACK as shown.
ACTUATOR / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (T) into the CABINET ACTUATOR (29G).
Diagram 3. Rotate the INTERLOCK TRACK and apply force to snap the second edge into the CABINET ACTUATOR.
å
Diagram 4. Repeat the ACTUATOR / TRACK ATTACHMENT for the next CABINET ACTUATOR while holding the previously
å
completed CABINET ACTUATOR in its location hole. Repeat these steps until all ACTUATORS have been attached.
Visually check that all INTERLOCK TRACK edges have been snapped into the CABINET ACTUATORS as shown in
å
diagram 3. Then, remove the INTERLOCK TRACK assembly from the END.
Do not slide the CABINET ACTUATORS
onto the INTERLOCK TRACK.
2.
Page 8
Cut out this rectangle to use as a "spacer"
The interlock system is a safety feature that prevents more than one drawer
from opening at the same time. Do not use excessive force to open the drawers.
A4
T
3.
29G
2-1/2"
T
4.
102702
1.
29G
www.sauder.com/services