Sauder Heritage Hill 102702 Manual De Instrucciones página 9

Step Step 4
Separate the EXTENSION SLIDES (P) from the EXTENSION RAILS (O) as shown in the upper diagram below. Be prepared,
å
the parts are greasy.
Lay the INTERLOCK TRACK (T) and CABINET ACTUATORS (29G) in the groove of the RIGHT END (A4) as shown.
å
Fasten two EXTENSION RAILS (O) to each END (A4 and B3). Use eight GOLD 5/16" FLAT HEAD SCREWS (FF).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge of the
å
EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten two ANGLE BRACKETS (U) to the ENDS (A4 and B3). Use two BLACK 9/16" LARGE HEAD SCREWS (CC).
å
NOTE: Be sure the edges of the ANGLE BRACKETS are even with the edges of the ENDS.
å
Push the black lever in and pull the SLIDE from the RAIL.
Finished edge
Open end
After fastening the EXTENSION RAILS to the RIGHT END (A4), the
CABINET ACTUATOR should touch the top edge of the RAILS. If the gap is
larger than 1/16", the drawers could lock up and not open. If this happens,
open two drawers at the same time to override the interlock system.
Remove the drawers to re-adjust the INTERLOCK TRACK assembly.
www.sauder.com/services
P
GOLD 5/16" FLAT HEAD SCREW
(8 used for the RAILS)
B3
O
U
FF
Finished edge
29G
T
O
A4
O
102702
O
BLACK 9/16" LARGE HEAD SCREW
(2 used for the ANGLE BRACKETS)
Open end
O
29G
O
CC
U
Page 9