Sauder Heritage Hill 102702 Manual De Instrucciones página 16

Step 11 Step
Flip the drawer over onto the LEFT DRAWER SIDE (D88).
å
Insert a SLIDE CAM (AA) into the RIGHT DRAWER SIDE (D87).
å
Diagram 1. Insert the tabs on a DRAWER ACTUATOR (BB) into the slots in a EXTENSION SLIDE (P). You may need to
å
insert one tab fi rst, then the other.
Diagram 2. Visually check that the DRAWER ACTUATOR (BB) is seated in the SLIDE (P).
å
Diagram 3. If the DRAWER ACTUATOR is not seated, use your hammer to gently tap the SLIDE until the tabs are properly
å
seated in the slots.
Now, fasten the EXTENSION SLIDE (P) to the RIGHT DRAWER SIDE (D87). Use two GOLD 5/16" FLAT HEAD SCREWS (FF)
å
through holes #1 and #4.
Repeat steps 10 and 11 for the remaining drawer.
å
1.
P
BB
These tabs must
insert into the slots.
Post
2.
P
BB
Page 16
Slot
D87
BB
Seated
Open end
1
2
P
3
4
D88
3.
102702
Screw head - turn CAM to
line up holes in the SLIDES
with holes in DRAWER SIDES
AA
FF
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services