Festo SPC200 Manual De Instrucciones página 19

Pin Signal
1 + PULSE
2 + DIRECT.
3 + ENABLE
4 not connected
5 + F/H STEP
6 − F/H STEP
7 not connected
8 + READY
1)
Not supported by stepping motor controller SEC−ST.
2)
Connections bridged in the connecting cable
(e.g. cable type KSPC−SECST−...).
The AMPLIFIER connection has been designed for stepping
motor controllers with 5 V control signals.
Use the special cables from the Festo range for connecting
the stepping motor controller.
If you use a stepping motor controller from a different
manufacturer, you must prepare a cable in accordance
with the manufacturer's instructions. In this case, connect
the cable screening on both sides with the plug housing.
Festo SPC200−SMX−1 0309a English
SEC−ST Pin Signal
Clk + 5 9 − PULSE
Dir + 5 10 − DIRECT.
EN + 5 11 − ENABLE
12 not connected
1)
13 not connected
1)
14 not connected
15 − READY
1) 2)
SEC−ST
Clk −
Dir −
En −
1) 2)
19