Troubleshooting; Technical Specifications; Service - Metabo KS 305 M Manual Original

15. Troubleshooting

Following you will find a description of problems
and faults that you may remedy yourself. If the
corrective measures described here do not help,
kindly refer to chapter 13. "Repairs".
Danger!
There are particularly many accidents in
connection with problems and faults. Therefore
keep in mind:
 Disconnect the mains plug prior to any fault

service.

 Check that all safety devices are operational
again after each fault service.
No trimming function
Transport lock activated:
 pull out transport lock.
Safety lock activated:
 loosen safety lock.
Cutting power too low
Saw blade blunt (possibly tempering marks on
blade body);
Saw blade unsuitable for the material (see
chapter 12. "Accessories");
Saw blade contorted:
 Replace saw blade (see chapter 10.
"Maintenance").
Saw vibrates a lot
Saw blade contorted:
 Replace saw blade (see chapter 10.
"Maintenance").
Saw blade not installed properly:
 Install saw blade properly (see chapter 10.
"Maintenance").
Turntable hard to turn
Chips under turntable:
 remove chips.

16. Technical Specifications

Explanatory notes on the specifications on page 3.
Subject to change in accordance with technical
progress.
U = mains voltage
I = rated power
F = min. fuse protection
P = rated input power
1
(S1= Permanent operation
S6= Continuous operation with
intermittent loading; corresponds to the
usual on/off operation for chop and mitre
saws)
IP = protection class
n = No-load speed
0
v = Max. cutting speed
0
D = saw blade diameter (outer)
d = saw blade hole (inside)
b = max. tooth width of the saw blade
A = dimensions (lxwxh)
m = weight
Requirements for chip and dust extraction unit:
D = connection diameter of the extraction
1
nozzle
D = minimum air throughput
2
D = minimum negative pressure at extraction
3
nozzle
D = minimum air speed at extraction nozzle
4
Maximum cross-section of workpiece, see table
on page 4.
~
AC Power
Direct current
Machine in protection class II
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be
higher or lower depending on the operating
conditions, the condition of the power tool or the
accessories. Please allow for breaks and periods
when the load is lower for assessment purposes.
All manuals and user guides at all-guides.com
Arrange protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Typical A-effective perceived sound levels:
L = sound-pressure level
pA
L = acoustic power level
WA
K , K = uncertainty
pA WA
Wear ear protectors!
ENGLISH en
17