Changing Batteries - Amazon 90DN160 Manual Del Usuario

Changing Batteries

WARNING
product from any circuit, remove the connector leads (O) from
the input jacks (F)/(G)/(H) and switch off the product before
opening the battery compartment (K). Do not operate the
product with an open battery compartment.
NOTICE
Replace the battery when the
indicator (10) is shown on the display (B).
• Open the tilt stand (N).
• Loosen the screws of the battery compartment cover (K)
and remove it.
• Insert a 9 V battery and attach it to the snap connector.
• Place the battery in the battery compartment (K) and close it.
• Tighten the screws of the battery compartment (K).
Operation
NOTICE
Keep the protection plugs of the connector leads
and reattach after use.
Switching the product on/off
• To switch the product on, set the function switch (E) to the
desired measurement mode.
• To switch the product off, set the function switch (E) to the
OFF position.
Risk of electric shock! Disconnect the
EN
low battery
13