Amazon 90DN160 Manual Del Usuario página 16

EN
DC voltage measurement
NOTICE
connector lead (O) is left on the ampere input jack (F) will blow
the product's internal fuse if it draws a current greater than the
internal fuses current rating. Check that the (+) red connector
lead (O) is on the correct terminal.
NOTICE
steady and normal operation. At unstable operation, large
voltage surges or current inrush may occur that can damage the
product.
• Set the function switch (E) to the
position.
• Press the MODE button
(D) to select the DC voltage
measurement. The DC indicator
(13) lights up.
• Insert the black connector lead (O)
into the negative COM input jack
(G).
• Insert the red connector lead (O)
into the V/Ω/Temp/Hz/%/mA/μA input jack (H).
• Connect the test probes (O) in parallel to the circuit under
test.
• The stabilized value on the display (B) is read as the actual
reading.
16
Doing voltage measurements while the (+) red
Risk of damage! Measure electric motors only in