Amazon 90DN160 Manual Del Usuario página 22

EN
• Press the MODE button (D) to switch nF capacitance mode.
nF unit of measurement indicator (8) lights up.
• Insert the black connector lead (O) into the negative COM
input jack (G).
• Insert the red connector lead (O) into the positive
input jack (H).
• Place the test probes (O) across the capacitor under test.
• The stabilized value on the display (B) is read as the actual
reading.
NOTICE
large capacitors to charge.
NOTICE
polarity (+, –) of its leads to have a precise measurement.
Temperature measurement
• Insert the thermocouple probe adapter (R) with the black
connector into the negative COM input jack (G) and with the
red connector into the positive V/Ω/Temp/Hz/%/mA/μA
input jack (H).
• Connect the thermocouple probe (Q) to the thermocouple
probe adapter (R). The polarity marking of the probe (Q)
must correspond to the marking of the adapter (R). The
probe pins are made in varying sizes to avoid a wrong
connection.
• Set the function switch (E) to the TEMP °C °F position.
• Press the MODE button (D) to change the temperature unit.
• Place the thermocouple probe tip to the component under
test.
22
The test may take up to 3 minutes or more for
When measuring electrolytic capacitors, follow the