Amazon 90DN160 Manual Del Usuario página 21

Continuity check
WARNING
shock, never measure continuity on circuits or wires that have
voltage on them.
• Set the function switch (E) to the
• Press the MODE button (D) to switch to
continuity indicator (5) lights up.
• Insert the black connector lead (O) into the negative COM
input jack (G).
• Insert the red connector lead (O) into the V/Ω/Temp/Hz/%/
mA/μA input jack (H).
• Place the test probes (O) across the circuit or part under
test.
• The stabilized value on the display (B) is read as the actual
reading.
• If the resistance is less than approximately 30 Ω, an audible
signal is emitted.
• If the circuit is open, OL lights up on the display (B).
Capacitance measurement
NOTICE
To avoid electric shock or measurement errors,
discharge the capacitor under test before measuring.
NOTICE
For best results, disconnect one side of the
component under test. This is to avoid the other components in
the circuit to inhibit the measurement.
• Set the function switch (E) to the
Risk of electric shock. To avoid electric
position.
continuity mode.
position.
EN
21