Amazon 90DN160 Manual Del Usuario página 20

EN
• Press the MODE button (D) to switch to Ω resistance mode.
Ω resistance measure unit indicator (8) lights up.
• Insert the black connector lead (O) into the negative COM
input jack (G).
• Insert the red plug of connector lead into the V/Ω/Temp/
Hz/%/mA/μA input jack (H).
• Place the test probes (O) across the circuit or part under
test.
• The stabilized value on the display (B) is read as the actual
reading.
Diode test
• Set the function switch (E) to the
• Press the MODE button (D) to switch to
mode.
• Insert the black connector lead (O) into the negative COM
input jack (G).
• Insert the red connector lead (O) into the V/Ω/Temp/Hz/%/
mA/μA input jack (H).
• Place the test probes (O) across the diode being measured.
• If the diode was measured in reverse, the display (B) shows
OL. Reverse the probes (O) position to get the correct
polarity.
NOTICE
shorted diode indicates near 0 V and an open diode indicates
OL in both polarities.
20
diode test indicator (4) lights up.
Forward voltage typically indicates 0.4 to 0.7 V. A
position.
diode test