Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
WARNING
when making measurements, if the voltages are greater than
25 V~ RMS or 35 V . These voltages are considered a shock
hazard.
WARNING
from the metal probe tips when taking measurements.
WARNING
near explosive vapors, dust or gases.
CAUTION
accuracy. Be careful when handling and reattach the probe tip
shrouds after use.
•
This product is intended for measurements on electrical
installations and is protected by double insulation as per
EN61010-1 to CAT III 600 V; Pollution Degree 2.
•
This product must be used by trained users only.
•
Do not measure current on a CAT III circuitry whose voltage
exceeds 600 V.
•
When measuring volts, do not switch to current/resistance
modes.
•
Set the function switch to the appropriate position before
measuring.
•
Set the function switch to the OFF position when not in use.
•
Inspect the condition of the connector leads and the product
for any damage before operation. Replace any damaged
accessory before use. Consult a professional repair centre
for any other repairs.
4
Risk of electric shock! Use special care
Risk of electric shock! Keep fingers away
Risk of explosion! Do not use the product
Risk of injury! The probe tips are sharp for
Publicidad
Tabla de contenido
