Care - Panasonic ER-GP21 Instrucciones De Operación

► Using the design blade
ER-GP22
The design blade enables to produce the
illustrated hair design.

Care

Removing and mounting the blade
• Make sure that the clipper is turned off.
Removing the blade
Hold the clipper with the switch facing
upward and push the blade with your
thumb while catching the blade in your
other hand.
Mounting the blade
Fit the mounting hook into the blade mounting on the clipper and
push in until it clicks.
Cleaning
• Clean the clipper and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the clipper is turned off.
1. Brush off any hairs from the
clipper and from around the
blade.
2. Brush off the hairs from the
blade edge.
3. Brush the hairs out from between
the stationary blade and the
moving blade while pressing
down on the cleaning lever (a)
to raise the moving blade.

11