Removing the attachment
Slide one side of the attachment off the
mounting in direction indicated with the
arrow.
Care
Removing and mounting the blade
• Make sure that the clipper is turned off.
Removing the blade
Hold the clipper with the switch facing
upward and push the blade with your thumb
while catching the blade in your other hand.
Mounting the blade
Fit the mounting hook into the blade mounting on the clipper and
push in until it clicks.
ER-GP30_EU.indb
11
Cleaning
• Clean the clipper and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the clipper is turned off.
1. Brush off any hairs from the
clipper and from around the
blade.
2. Brush off the hairs from the
blade edge.
3. Brush the hairs out from between
the stationary blade and the
moving blade while pressing
down on the cleaning lever (a)
to raise the moving blade.
11
2016/05/06
17:51:45