Publicidad
Step 19
Step
Carefully turn your unit over onto its front edges. Lay the
å
BACKS (R) over your unit.
Make equal margins along all eight edges of the BACKS (R).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACKS (R) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the SHELF (P).
NOTE: Perforations have been provided for access through
å
the BACKS. Carefully cut out the holes needed.
Push the FOOT (3E) into the hole in the BOTTOM (O).
å
These holes must line
up over the SHELF (P).
Page 24
These holes must line
up over the SHELF (P).
P
R
O
417698
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(42 used in this step)
R
3E
www.sauder.com/services
1N
Publicidad
